Site Grade

—Laser HI
Site plan
Tap where you're standing to take a shot

Project

1 · Shoot the benchmark

Set the rod on the benchmark (e.g. finished slab) and read the rod at the laser beam.
Laser height of instrument (HI)
—

2 · Re-check benchmark

Do this every couple of hours or if the laser may have been bumped.

GPS on the plan

Lines the plan up with the phone's GPS using control points (purple crosshairs). Defaults are the 4 building corners – move, rename, add or delete them on the Plan tab in 📍 Cal mode. Stand on each one and tap Capture GPS here.
Uses the plan's 1"=30' scale so only position and rotation come from GPS. Turn off only if the plan image isn't to scale.

Settings

Plans show spot elevations like 14.33 meaning 1014.33. Anything you type under 100 gets this prefix added.

Target points

Pre-loaded points (curb corners, grade breaks, pad corners) the super just taps and shoots. Add them on the Plan tab with + Point.

Shot log

#TimePointTargetRodResult

New shot

inches
—
Enter plan elevation and rod reading

Control point

Stand exactly on this spot and capture GPS. Hold the phone still at chest height.